Label specifications – Zebra Technologies R170XiTM User Manual
Page 158
146
R110Xi/R170Xi User Guide
23063L-003 Rev. 2 12/23/04
Specifications
Label Specifications
Label Specifications
R110Xi/R170Xi printers need the correct size and type of labels for best performance. Refer to
the tables that follow for the specifications.
Important •
Media registration and minimum label length are affected by label type and
width, ribbon type, print speed, and printer mode of operation. Performance improves as these
factors are optimized. Zebrarecommends qualifying any application with thorough testing.
Label Specifications
R110Xi
R170Xi
Minimum label length
Tear-off
0.7 in. (18 mm)*
0.7 in. (18 mm)*
RFID labels
**
**
Total media width
(label + backing, if any)
Minimum
0.79 in. (20 mm)*
2.00 in. (51 mm)
Maximum
4.5 in. (114 mm)
7.1 in. (180 mm)
RFID labels
**
**
Total thickness
(includes backing, if any)
Minimum
0.003 in. (0.076 mm)
0.003 in. (0.076 mm)
Maximum
0.012 in. (0.305 mm)
0.012 in. (0.305 mm)
Roll media core inside diameter
3 in. (76 mm)
3 in. (76 mm)
Maximum roll diameter on
3 in. (76 mm) core
8.0 in. (203 mm)
8.0 in. (203 mm)
Interlabel gap
Minimum
0.079 in.(2 mm)*
Preferred
0.118 in. (3 mm)*
Maximum
No more than the
calibrated length of the
label.
No more than the
calibrated length of the
label.
RFID labels
**
**
Maximum internal fanfold media
pack size (label + backing)
L × W×H
R110Xi 200 dpi
8.0Ч4.5Ч4.5 in.
(20Ч114Ч114 mm)
8.0Ч7.1Ч4.5 in.
(203Ч114Ч114 mm)
R110Xi 300 dpi
8.0Ч5.5Ч4.5 in.
(203Ч140Ч114 mm)
Ticket/tag sensing notch L × W
0.12×0.25 in. (3×6 mm) 0.12×0.25 in. (3×6 mm)
Ticket/tag sensing hole diameter
0.125 in. (3 mm)
0.125 in. (3 mm)
Label registration tolerance
(vertical)
± 0.06 in. (± 1.5 mm)
± 0.070 in. (± 1.8 mm)
Label registration tolerance
(horizontal)
± 0.06 in. (± 1.5 mm)
± 0.070 in. (± 1.8 mm)
* Does not apply to RFID labels.
** This parameter varies for each transponder type. For the list of approved transponders, go to