Yamaha RX-797 - Manual (Page 13)

CONTROLS AND FUNCTIONS
9
INTR
ODUCTION
This section describes the function of each button on the
Zone 2 remote control used to control Zone 2. You can
also use the Zone 2 remote control to control the XM
Satellite Radio features and YAMAHA CD players.
1 Infrared signal transmitter
Sends infrared signals.
2 Input selector/numeric buttons
Select the desired input source of Zone 2.
Enter a channel number or preset channel number when
XM is selected as the input source.
You must press and hold NUMBER before you press any of these
buttons to enter numbers.
3 PRESET u / d
Selects the preset station number (1 to 8) when TUNER is
selected as the input source.
4 A/B/C/D/E
Selects the preset station group (A to E) when TUNER is
selected as the input source.
5 XM Satellite Radio control buttons
Controls the XM Satellite Radio features when the
CD/XM switch is slid to the XM position.
A-E/CAT. (CATEGORY) l / h
Switches between channel categories or selects the
preset channel group (A to E) when XM is selected as
the input source.
PRESET/CH k / n
Searches for a radio channel or selects the preset
channel number (1 to 8) when XM is selected as the
input source.
ALL
Selects the All Channel Search mode.
PRESET
Selects the Preset Search mode.
CAT. (CATEGORY)
Selects the Category Search mode.
6 ID1/ID2 switch
Switches the remote control ID between ID1 and ID2 (see
page 40).
7 POWER
Turns on Zone 2.
8 STANDBY
Sets Zone 2 to the standby mode.
9 ENT (ENTER)
Confirms an entered channel number during the Direct
Number Access mode when XM is selected as the input
source.
0 VOLUME +/–
Increases or decreases the sound output level of Zone 2.
This does not affect the OUT (REC) level.
Zone 2 remote control
Note
CD
1
PHONO
ZONE 2
2
TUNER
3
MD/TAPE
4
VCR
5
DTV/CBL
ENT 6
DVD
7
XM
8 9 0
POWER
STANDBY
+
–
u
d
lA-E/CAT. k
n
A-E/CAT.h
CAT.
DISC
ALL
p
PRESET PRESET/CH
NUMBER
A/B/C/D/E
MUTE
PRESET VOLUME
XM CD ID2 ID1
w e f
b s a
DISPLAY
7
8
9
0
A
B
C
D
1
2
3
4
5
6
(U.S.A. model)
Note