Yamaha RX-797 - Manual (Page 49)

45
REMOTE CONTROL FEATURES
AD
V
A
NCED
OP
ERA
T
IO
N
You can control other components by setting the
appropriate remote control codes. Codes can be set up for
each input source. For a complete list of available remote
control codes, refer to “LIST OF REMOTE CONTROL
CODES” at the end of this manual.
The following table show the default component category
(library) and the remote control code for each input
source.
Remote control code default settings
* You can only set the TV remote control codes for the DTV/
CBL button. However, other remote control codes can be set
for any input selector buttons except DTV/CBL.
You may not be able to operate your other YAMAHA
components even if the YAMAHA remote control code is
initially set as listed above. In this case, try setting other
YAMAHA remote control codes.
1
Press and hold CODE SET on the remote
control and then press one of the input
selector buttons on the remote control to
select the input source you want to set up.
You must press and hold CODE SET throughout this
operation.
2
While holding down CODE SET on the
remote control, use the numeric buttons on
the remote control to enter the three-digit
remote control code for the selected input
source.
When the setting succeeds, “PRESET OK” appears;
however, when it does not, “PRESET NG” appears in
the front panel display.
To reset the code, enter the default code for each
input source listed in the remote control code default
settings table.
• If the manufacturer of your component has more than one
code, try setting each of them until you find the correct
one.
• You can only assign one remote control code to each input
selector button.
Setting remote control codes
Input
source
Default
component
category
(library)
Manufacturer
Default
YAMAHA
code
CD CD YAMAHA 199
MD/TAPE TAPE YAMAHA 499
DVD DVD YAMAHA 699
DTV/CBL*
— — —
VCR — — —
PHONO — — —
Note
Note
Notes
MENU
CODE SET
STANDBY POWER
CD MD/TAPE TUNER
PHONO DVD
POWER POWER
AV TV
VCR DTV/CBL
XM
MENU
CODE SET
MENU TITLE
SRCH MODE BAND
A-E/CAT. A-E/CAT.
PRESET/CH
4 3 2 1
8
10
7
0 9
6 5
ENT.
DISPLAY RETURN
MEMORY
ENTER