Yamaha ACD1 - Manual (Page 2)

ACD1 Reference Manual 2
Contents
Introduction............................................. 3
About the documentation .................................3
Supported amplifiers .........................................3
Setup ...................................................................3
Terms ..................................................................4
Controls and Connectors ...................... 5
Front Panel .........................................................5
Rear Panel ..........................................................6
Panel operations .................................... 7
Basic operation ..................................................8
Scene (“1. Scene”)...........................................10
Recalling a scene (“1. Scene” ➝ “Recall”) ............ 10
Storing a scene (“1. Scene” ➝ “Store”)................. 10
Controlling an amplifier (“2. Amp Control”)..11
Power on/standby
(“2. Amp Control” ➝ “Standby”)....................... 11
Mute (“2. Amp Control”
➝ “Mute”)......................... 11
Attenuator value adjustment
(“2. Amp Control”
➝ “Attenuation”).................. 11
Amplifier output monitor
(“3. Output Monitor”) .......................................12
Amplifier output (“3. Output Monitor”) ................... 12
Device setup (“4. Device Setup”) ...................12
Device ID setting
(“4. Device Setup” ➝ “Device ID”) ................... 12
View ACD1 name
(“4. Device Setup”
➝ “Device Label”) .............. 12
Identify (“4. Device Setup” ➝ “Identify”) ................ 13
Utility (“5. Utility”) ............................................13
Backup battery check (“5. Utility”
➝ “Battery”) ...... 13
Version indication (“5. Utility” ➝ “Firmware Ver.”) .. 13
LCD backlight (“5. Utility” ➝ “LCD Backlight”)....... 14
Restricting panel operations
(“5. Utility” ➝ “Panel Operation”) ..................... 14
Enabling scene recall operations from the panel
(“5. Utility” ➝ “Scene Recall”) .......................... 14
Enabling scene recall operations via
EMG commands
(“5. Utility”
➝ “EMG Scene Setup”) ................. 15
LAST MEMORY RESUME setting
(“5. Utility” ➝ “Last Mem. Resume”) ................15
Clock setting (“5. Utility” ➝ “Clock”).......................15
GPI IN calibration
(“5. Utility” ➝ “GPI Calibration”) .......................16
Network settings (“6. Network Setup”) ..........16
IP Address Mode setting
(“6. Network Setup” ➝ “IP Address Mode”).....16
IP Address setting
(“6. Network Setup” ➝ “IP Address”)...............16
Checking the MAC address
(“6. Network Setup”
➝ “MAC Address”) ..........16
Port settings for an external controller
(“6. Network Setup” ➝ “IP Ctrl Port #”)............17
Initializing the ACD1 ........................................17
Connector wiring .................................. 18
Euroblock plug connection.............................18
GPI connector ..................................................19
FAULT OUTPUT connector .............................20
Appendix ............................................... 21
Display messages ............................................21
List of supported characters ..........................21
Troubleshooting...............................................22
Specifications...................................................22
Control I/O ........................................................23
Pin Assignment ................................................23
MONITOR/REMOTE............................................. 23
DATA PORT .......................................................... 23
Dimensions.......................................................24