Yamaha RX-V1000RDS - Manual (Page 24)

22
ADJUSTING THE SPEAKER OUTPUT LEVELS
This section explains how to adjust the speaker output
levels by using the test tone generator. When this
adjustment is made, the output level heard at the listening
position will be the same from each speaker. This is
important for the best performance of the digital sound
field processor, the Dolby Pro Logic decoder, Dolby
Digital decoder and DTS decoder.
Note
• Since this unit cannot enter the test mode while headphones are
connected to this unit, be sure to unplug the headphones from
the PHONES jack when using the test tone.
Before You Begin
STANDBY
/ON
1 Press STANDBY/ON to turn on the power.
Turn on the video monitor.
2 Press SPEAKERS A or B
to select the main
speakers to be used.
If you are using two sets of the
main speakers, press both A
and B.
BASS
EXTENSION
PROCESSOR
DIRECT
ON OFF
BASS
– +
TREBLE
– +
Remote control
PARAMETER
SET MENU
VCR2 /DVR V-AUX
VCR 1 CBL/SAT
D-TV/LD DVD SOURCE
REC OUT
A/B/C/D/E
SPEAKERS A B BASS EXTENSION PROCESSOR DIRECT
PRESET/ TUNING MD/TAPE CD-R TUNER
CD
PHONO
BASS
6CH INPUT VOLUME INPUT INPUT MODE
– +
TREBLE
– +
PRESET
/TUNING
EDIT
MEMORY
MAN'L/AUTO FM
TUNING MODE
AUTO/MAN'L MONO
RDS MODE /FREQ EON PTY SEEK
MODE START
FM/AM
PHONES S VIDEO VIDEO L AUDIO R OPTICAL
SILENT VIDEO AUX
EFFECT PROGRAM ON OFF
SURROUND
D I G I T A L
D I G I T A L
STANDBY /ON
1
2 3 3
DISC
ON SCREEN LEVEL
SLEEP TEST
PARAMETER
SET MENU
4
SPEAKERS
A B
Front panel
3 Set BASS and TREBLE on the front panel to
the center position and set BASS
EXTENSION to OFF.
Front panel
4 Sit in the listening
position and set
PARAMETER/SET MENU
on the remote control to
PARAMETER.
Front panel
Set to OFF.
0104V1000RDS_19-23_EN 9/5/0, 4:41 PM 22