Yamaha RX-V1000RDS - Manual (Page 31)

29
English
INTRODUCTION
PREP
ARA
TION
BASIC
OPERA
TION
AD
V
ANCED
OPERA
TION
ADDITIONAL
INFORMA
TION
APPENDIX
BASIC PLAYBACK
■ Virtual CINEMA DSP and SILENT
CINEMA DSP
You can experience the virtual CINEMA DSP sound field
by setting “1C REAR L/R SP” on the SET MENU to
NONE. The sound field processing is changed to the
Virtual CINEMA DSP mode according to the selected
DSP program. Virtual CINEMA DSP is performed by
using the main speakers. You can also listen to SILENT
CINEMA DSP by connecting your headphones to the
PHONES jack while the digital sound field processor is
on.
Note
• This unit is not set in the virtual CINEMA DSP mode even if
“1C REAR L/R SP” is set to NONE in the following cases:
– when the 6ch Stereo, DOLBY DIGITAL/Normal or DTS/
Normal program is selected;
– when the sound effect is turned off;
– when 6CH INPUT is selected as the input source;
– when 96-kHz sampling digital signals are input to this unit;
– when the Dolby Digital KARAOKE source is played;
– when using the test tone; or
– when connecting the headphones.
EFFECT EFFECT
Front panel
or
Remote control
Notes
• If you turn off the sound effect, no sound is output from the
center, rear and rear center speakers.
• If you turn off the sound effect while a Dolby Digital or DTS
signal is being output, the dynamic range of the signal is
automatically compressed and the sounds of the center, rear
and rear center channels are mixed and output from the main
speakers.
• The volume may be greatly reduced when you turn off the
sound effect or if you set “10B D-RANGE” on the SET MENU
to MIN. In this case turn on the sound effect.
Normal Stereo Reproduction
Press EFFECT to turn off the sound effect
for normal stereo reproduction.
Press EFFECT again to turn the sound effect back
on.
0105V1000RDS_24-29_EN 9/5/0, 4:42 PM 29