ZyXEL Communications NSA210 - Manual (Page 31)

Chapter 2 NAS Starter Utility
NSA210 User’s Guide
31
If the computer on which you are running the NAS Starter Utility has more than
one active network interface, the Network Interface Card List screen appears
as follows.
Figure 6 Select Network Interface Card
Highlight one interface and then click Select to use that interface. The NAS
Starter Utility will continue to use this interface until you exit the NAS Starter
Utility and run it again.
Note: This screen does not show up if the computer on which you are running the
NAS Starter Utility only has one active network interface. Skip this section and
see the Device List screen (
Section 2.5 on page 31 ).
2.5 Device List Screen
Use this screen to view all host names, IP addresses and status of all NSAs in your
network. The host name is the Server Name of your NSA (default is ‘NSA210’)
that you can change (see
Section 2.6 on page 34 ) to a more recognizable one in
your network.
If the firmware is installed in your NSA, you can also access the Web Configurator
and map your NSA to your local computer in this screen.
Start the NAS Starter Utility (click the icon in your Desktop or in Start >
Programs > ZyXEL > NAS Starter Utility). The NAS Starter Utility main screen
appears as follows.