Sony SLV-SE100A2 User Manual
Page 7
Getti
ng Sta
rted
7
Setting up the remote commander
Notes
• With normal use, the batteries should last about three to six months.
• If you do not use the remote commander for an extended period of time, remove the batteries
to avoid possible damage from battery leakage.
• Do not use a new battery together with an old one.
• Do not use different types of batteries together.
• Some buttons may not work with certain Sony TVs.
Controlling other TVs with the remote commander
(SLV-SE300D1/D2 and SE480D only)
The remote commander is preprogrammed to control non-Sony TVs. If your TV is
listed in the following table, set the appropriate manufacturer’s code number.
* These buttons may not work with all TVs.
Switch to/from wide mode of a Sony wide TV (For other
manufactures’ wide TVs, see “Controlling other TVs with
the remote commander (SLV-SE300D1/D2 and SE480D
only)” below.)
WIDE
1
Set [TV] / [VIDEO] at the top of the remote commander to [TV].
2
Hold down ?/1, and enter your TV’s code number using the programme number
buttons. Then release ?/1.
Now you can use the following TV control buttons to control your TV:
?/1, t TV/VIDEO, programme number buttons, - (ten’s digit), PROG +/–,
2 +/–, WIDE*, MENU*,
M
/
m
/
<
/
,
*, and OK*.
To
Press
continued