Zanussi ZOP37902 - Manual (Page 16)

1. Remove the removable shelf supports (if applicable)
and accessories from the appliance. Refer to "Re-
moving the shelf supports".
Caution! Do not let the removable shelf supports
stay in the appliance during Pyro Cleaning. There is
a risk of damage.
2. Remove the worst dirt manually.
3. Fully close the oven door.
The Pyro Cleaning procedure cannot start if you do
not close the oven door.
4. Set the function Pyro Cleaning. Refer to "Oven func-
tions".
5. When flashes, press + or - to set the necessary
procedure:
– P1 - if the oven is not very dirty. The procedure is
1 h long.
– P2 - if the oven is more dirty. The procedure is 1
h 30 min long.
6. Press to start the procedure. You can use the
End function to delay the start of the cleaning.
When the oven is at the set temperature, the door
locks. The display shows the symbol and the
bars of the heat indicator.
To stop Pyro Cleaning before it is completed, turn
the knob for the oven functions to the off position.
When Pyro Cleaning is completed, the display shows the
time of day. The oven door stays locked. When the appli-
ance is cool again, an acoustic signal sounds and the
door unlocks.
During Pyro Cleaning the oven lamp is off.
Cleaning reminder
To remind you that Pyro Cleaning is necessary, PYR
flashes in the display for 10 seconds after each activation
and deactivation of the appliance.
The cleaning reminder goes out:
• After the end of the Pyro Cleaning function
• If you press + or - when flashes in the display.
Oven lamp
Warning! Be careful when you change the oven
lamp. There is a risk of electrical shock.
Before you change the oven lamp:
• Deactivate the oven.
• Remove the fuses in the fuse box or deactivate the cir-
cuit breaker.
Put a cloth on the bottom of the oven to prevent
damage to the oven light and glass cover.
Always hold the halogen lamp with a cloth to prevent
grease residue from burning on the lamp.
1. Turn the glass cover counterclockwise to remove it.
2. Clean the glass cover.
3. Replace the oven light bulb with an applicable 300
°C heat-resistant oven light bulb.
Use the same oven lamp type.
4. Install the glass cover.
Cleaning the oven door
The oven door has three glass panels. You can remove the
oven door and the internal glass panels to clean them.
The oven door can close if you try to remove the
glass panels before you remove the oven door.
Removing the oven door and the glass panels
1 Open the door fully
and hold the two door
hinges.
2 Lift and turn the levers
on the two hinges.
16
www.zanussi.com