Zanussi ZOP37902 - Manual (Page 7)

Clock functions
Symbol Function Description
Minute Minder To set a countdown time.
Time of day To set, change or check the time of day. Refer to "Setting the time of day".
Duration To set how long the appliance must operate. First set an oven function before you
set this function.
End To set when the appliance must be deactivated. First set an oven function before
you set this function. You can use Duration and End at the same time (Time De-
lay) to set the time when the appliance must be activated and then deactivated.
Press again and again to change the clock func-
tion.
Press to confirm the settings of the clock func-
tions, or wait 5 seconds for the setting to be con-
firmed automatically.
Setting the Duration or End function
1. Press again and again until the symbol or
flashes in the display.
2. Press + or - to set the minutes.
3. Press to confirm.
4. Press + or - to set the hour.
5. Press to confirm.
6. When the set time ends, the symbol
or and
the set time flash. The acoustic signal sounds for
two minutes. The appliance deactivates. Press a but-
ton or open the appliance door to stop the signal.
If you press while setting the time for Duration
, the appliance switches to setting the End
function.
Setting the Minute Minder
Used to set a countdown time. The maximum time you
can set is 23 hours 59 minutes. This function has no ef-
fect on the operation of the oven. You can set the Minute
Minder at any time, also if the appliance is off.
1. Press again and again until and 00 flash in
the display.
2. Press + or - to set the Minute Minder. At first the
time is calculated in minutes and seconds. When the
time you set is longer than 60 minutes, the symbol
comes on in the display. The appliance then
calculates the time in hours and minutes.
3. The Minute Minder starts automatically after five
seconds.
4. When the set time ends, the acoustic signal sounds
for two minutes. 00:00 and flash in the display.
Press a button to stop the signal.
If you set the Minute Minder when the Duration
or End
function operates, the symbol comes
on in the display.
Count Up Timer
Use the Count Up Timer to monitor how long the oven op-
erates. It is on immediately when the oven starts to heat.
To reset the Count Up Timer, press and hold + and -. The
timer starts to count up again.
You cannot use the Count Up Timer when the Dura-
tion
or End function operates.
Using the accessories
Warning! Refer to "Safety information" chapter.
Trivet and grill/roasting pan
Warning! Be careful when you remove the
accessories from a hot appliance. There is a risk of
burns.
7
www.zanussi.com