3Com Wireless LAN WX1200 - Manual (Page 287)

clear {ap | dap} radio 287
Defaults — The clear ap radio command resets the radio to the default
settings listed in Table 50 and in Table 66 on page 362.
Access — Enabled
History —Introduced in MSS Version 3.0.
Usage — When you clear a radio, MSS performs the following actions:
„
Clears the transmit power, channel, and external antenna setting from
the radio.
„
Removes the radio from its radio profile and places the radio in the
default radio profile.
This command does not affect the PoE setting.
Examples — The following command disables and resets radio 2 on the
MAP access point connected to port 3:
WX1200# clear ap 3 radio 2
Table 50 Radio-Specific Parameters
Parameter Default Value Description
channel
„
802.11b — 6
„
802.11a — Lowest
valid channel number
for the country of
operation
Number of the channel in
which a radio transmits and
receives traffic
tx-power Highest setting allowed for
the country of operation
or highest setting
supported on the
hardware, whichever is
lower. Transmit power of a radio, in
decibels referred to
1 milliwatt (dBm)
antennatype For most MAP models, the
default is internal.
For MP-620, the default
for the 802.11b/g radio is
ANT-1360-OUT. The
default for the 802.11a
radio is ANT-5360 OUT.
The default for the
802.11b/g radio on model
MP-262 is ANT1060.
External antenna model
Note: This parameter is
configurable only on MAPs
that support external
antennas.