3Com Wireless LAN WX1200 - Manual (Page 487)

clear radius client system-ip 487
WX4400# clear radius timeout
success: change accepted.
See Also
„
set radius on page 490
„
set radius server on page 494
„
display aaa on page 219
clear radius client
system-ip Removes the WX switch’s system IP address from use as the permanent
source address in RADIUS client requests from the switch to its RADIUS
server(s).
Syntax — clear radius client system-ip
Defaults — None.
Access — Enabled.
History —Introduced in MSS Version 3.0.
Usage — The clear radius client system-ip command causes the WX
switch to use the IP address of the interface through which it sends a
RADIUS client request as the source IP address. The WX switch selects a
source interface address based on information in its routing table as the
source address for RADIUS packets leaving the switch.
Examples — To clear the system IP address as the permanent source
address for RADIUS client requests, type the following command:
WX4400# clear radius client system-ip
success: change accepted.
See Also
„
display aaa on page 219
„
set radius client system-ip on page 491