3M SCP717 - Manual (Page 22)

© 3M 2008. All Rights Reserved. 17
3M™ Super Close Projection System Installation
Adjusting the Projected Image
Adjusting the Projector Image Height
The projector is equipped with elevator feet for adjusting
the image height.
To raise the image:
1. Press the elevator buttons  .
2. Raise the image to the desired height angle  , then re-
lease the button to lock the elevator feet into position.
3. Rotate the tilt adjusting foot  to fine-tune the display
angle.
To lower the image:
1. Press the elevator buttons.
2. Lower the image, then release the button to lock the
elevator feet into position.
3. Rotate the tilt adjusting foot  to fine-tune the display
angle.
Elevator Feet Tilt Adjusting Foot Elevator Feet
Elevator Buttons
1 1
2 2 3