3M SCP717 - Manual (Page 38)

© 3M 2008. All Rights Reserved. 33
3M™ Super Close Projection System User Controls
Tint
Adjust the color balance of red and green.
 Press the to increase the amount of green in the image.
 Press the to increase the amount of red in the image.
Gamma
This unit comes with 4 preset gamma curves. After the initial setup
and fine tuning is completed, utilize the Gamma Adjustment steps to
optimize your image output.
White Intensity
Use the white peaking control to set the white peaking level of DMD
chip. 0 stands for minimal peaking, and 10 stands for maximum
peaking. If you prefer a brighter image, adjust towards the maximum
setting. For a smooth and more natural image, adjust towards the
minimum setting.
Color
 Color Temperature: Adjust the color temperature. At higher
temperature, the screen looks colder; at lower temperature, the
screen looks warmer.
When you adjust the color setting item, the color temperature will
be set as “User” automatically. And this set “User” is the same for
all display mode.
 Gain Red/ Gain Green/ Gain Blue: Adjust the contrast of the
individual colors.
 Offset Red/ Offset Green/ Offset Blue: Adjust the brightness of
the individual colors.