Edimax Technology BR-6675nD - Manual (Page 77)

76
2.4GHz (B+G+N): Allows 802.11b, 802.11g, and
802.11n wireless clients to connect to this router
(recommended).
ESSID This is the name of your router. You can type any
alphanumerical character here (maximum 32
characters).
Channel Number Select a channel from the dropdown menu. All access
points must use the same channel (1 to 13).
Associated Clients Click “Show Active Clients” for the list of all
connected wireless clients. Click “Refresh” in the
new window to renew the list, and click “Close” to
close the window.
Note: If you have a pop‐up blocker installed, you
may have to disable it, or set it to allow the pop‐up
window to show up.
MAC address 1 to 4 Input the MAC addresses of the wireless access points
with which you wish to connect.
Wireless Module Select “Enable” to turn on the 2.4GHz wireless
signal and select “Disable” to turn it off.
Click “Apply” to save the changes, or click “Cancel” to discard the changes. After you
have clicked “Apply”, you will see the following message:
Click “Apply” to save the changes and restart the broadband router. It takes about 60
seconds for the broadband router to restart. Click “Continue” to configure other settings.