SUUNTO VYTEC DS - Manual (Page 15)

13
2.4. WIRELESS CYLINDER
PRESSURE TRANSMISSION
The Vytec can be used together with an
optional wireless cylinder pressure transmitter
that can easily be attached to the high-pres-
sure port of the regulator (Fig. 2.5). By using
the transmitter the diver can benefi t from cylin-
der pressure and remaining air time data.
In order to use the transmitter the wireless
integration needs to be enabled in the Vytec’s
settings. To enable or disable the wireless
integration refer to chapter 4.3.3.3 Cylinder
pressure settings.
2.4.1. Installing the Transmitter
Upon purchasing the Vytec, Suunto strongly
recommends you have your dealer attach the
transmitter to the fi rst stage of your regulator.
If you decide to attach it yourself, follow the
steps outlined below:
Remove the high pressure (HP) port plug
on the fi rst stage of your regulator using an
appropriate tool.
Thread the high pressure transmitter of the Vy-
tec into the HP port of your regulator with your
fi ngers. DO NOT OVERTIGHTEN! Maxi mum
torque 6 Nm (4.4 ftlbs or 53 inlbs). Sealing is
based on a static o-ring, not force!
Attach the regulator to the scuba cylinder.
Slowly open the valve. Check for leaks by
submerging the regulator fi rst stage in water.
If leaks are detected, check the condition of
the o-ring and sealing surfaces.
Fig. 2.4. Active water
contacts are indicated
by the text AC.
Fig. 2.5. Vytec’s optional
wireless pressure trans-
mitter.