SUUNTO VYTEC DS - Manual (Page 53)

51
multiple gas mixes are set they will be changed
as soon as allowed maximum depth is reached
upon ascent and in the order of: MIX1, MIX2
and MIX3
To enter the Dive Simulator mode select
MODE- 2 SIMUL- 1 SIMDIVE (Fig. 4.17. and
4.18.).
4.2.2. Dive Planning Simulator
[2 SIMPLAN]
The Dive Planning Simulator mode shows you
the present no-decompression limits. In this
mode, you are also able to add the desired
surface interval increment to present surface
interval time, which allows you to plan your
dives in advance.
This mode is also used to add the desired
surface intervals for dive simulations. Add the
desired surface interval increment to present
surface interval by pressing the arrow down
(TIME) and arrow up (PLAN) buttons.
NOTE! This display is only shown for repeti-
tive dives.
To enter the Dive Planning Simulator mode
select MODE- 2 SIMUL- 2 SIMPLAN (Fig.
4.19.).
NOTE! The Dive Planning Simulator mode is
disabled in Gauge mode and in Error mode
(see section 3.9. ”Error Conditions”).
4.3. SET MODES [3 SET]
The Set Modes (Fig. 4.22.) are divided into
three submodes for setting the dive-related
parameters, time-related parameters and your
personal preferences.
Fig. 4.20. Selected Dive
Planning Simulator
mode. Add desired
surface interval incre-
ment (to present shown
surface interval) by
pressing TIME and PLAN
buttons. This display is
only shown
for repetitive dives.
Fig. 4.21. Dive Planning
Simulation.
TIME
SURF
OK
QUIT
DIVE
NO DEC TIME
MAX
Fig. 4.22. Setting Op-
tions. [3 SET].
QUIT
OPTIONS