SUUNTO VYTEC DS - Manual (Page 37)

35
Tank pressure and ascent rate indicator are
also displayed during the dive (Fig. 3.28.).
Remaining Air Time, temperature and current
time are shown in the alternative display when
the TIME button is pressed.
NOTE! If you dive with the Gauge mode, it is
not possible to change between the modes
within 48 hours.
3.6. AT THE SURFACE
3.6.1. Surface Interval
An ascent to any depth shallower than 1.2 m [4
ft] will cause the DI VING display to be replaced
by the SURFACE display, giving the following
information (Fig. 3.29.):
• maximum depth of last dive in me -
ters [ft]
• present depth in meters [ft]
• no-fl ying warning indicated by an air -
plane icon (Table 3.3)
• Altitude Adjustment setting
• Personal Adjustment setting
• Diver attention symbol indicates
attenuated RGBM model has been
set
• Flashing Diver attention symbol
indicates surface interval time should
be prolonged (Table 3.3)
• STOP label for 5 min, if the Mandatory
Safety Stop was violated
• Er, if the decompression ceiling was
violated (= Error Mode) (Fig. 3.32,
Table 3.3)
• Cylinder pressure in bars [psi] (if “on”,
if “off” temperature is shown)
• dive time of last dive in minutes, shown
as DIVE TIME.
Fig. 3.28. Diving in
Gauge mode. Current
dive time is 30 minutes
21 seconds.
Fig. 3.29. Surface dis-
play. You have surfaced
from a 18 minute dive,
which maximum depth
was 20.0 m [66 ft]. The
present depth is 0.0 m
[0 ft].Airplane symbol
indicates that you should
not fl y and blinking Diver
Attention Symbol
indicates that you should
prolong your surface
interval time because of
excess micro-bubbles.
m
MAX
DIVE TIME bar
MAX
TIME DIVE
m
NO
bar