SUUNTO Vyper Air - Manual (Page 22)

ADJUST WITH
UP AND DOWN
BUTTONS.
ACCEPT WITH
SELECT BUTTON.
ADJUST WITH
UP AND DOWN
BUTTONS.
ACCEPT WITH
SELECT BUTTON.
NOTE If MIX2 is set ON, settings for all mixes are stored until changed. If
MIX2 has an oxygen content of 22% or greater, settings for all mixes
are stored until changed.
5.8.4. Setting the personal/altitude adjustments
The current Altitude and Personal Adjustment settings are displayed in the startup screen
when entering the DIVE mode. If the mode does not match the altitude or personal
conditions (see Section 5.9.4. Diving at altitude and Section 5.9.5. Personal adjustments),
it is imperative that you enter the correct selection before diving. Use Altitude Adjustment
to select the correct altitude and use Personal Adjustment to add an extra level of
conservatism.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.8.5. Setting the sample rate
The sample rate controls how often the depth, time, tank pressure, and water temperature
is stored in the memory.
You can set the dive profile sample rate to 1, 10, 20, 30, or 60 seconds. The factory default
setting is 20 seconds.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
5.8.6. Setting the Safety Stops/Deep Stops
The Deep Stop setting allows you to view Deep Stops. If Deep Stops are set to OFF, only
the traditional Safety Stop calculation is used.
If set to ON, iterative Deep Stops will be prompted as well. The length of the individual
Deep Stops can be set to 1 or 2 minutes.
ADJUST WITH UP AND
DOWN BUTTONS. ACCEPT
WITH SELECT BUTTON.
22