SUUNTO Vyper Air - Manual (Page 29)

6. DIVING
This section contains instructions on how to operate the dive computer and interpret its
displays. You’ll find that this dive computer is easy to use and read. Each display shows
only the data relevant to that specific diving mode.
6.1. Diving in AIR mode (DIVEair)
In this section, we look at how to make the most of the dive computer when diving with
standard air. To activate DIVEair mode, please see Section 5.9.1. Accessing DIVE mode.
DIVE HAS JUST BEGUN AN D
AVAILABLE NO-DECOMPRESSION
TIME IS OVER 99 MINUTES SO NO
VALUE IS DISP LAYED.
NOTE The dive computer will remain in the Surface mode at depths less
than 1.2 m/4 ft. At depths greater than 1.2 m/4 ft the instrument will
go into the DIVE mode automatically. However, it is recommended
that you activate the Surface mode manually before entering the water
in order to perform the necessary dive pre-checks.
6.1.1. Basic dive data
During a No-decompression dive, the following information is displayed:
•
your present depth in meters/feet
• the available no-decompression time in minutes as NO DEC TIME
• the ascent rate presented as a bar graph on the right side
• the Diver Attention Symbol if surface interval should be prolonged (see Table 7.1,
Alarms)
• the Deep Stop depth, if activated
DIVE DISPLAY - PRESENT DEPTH IS 15 M,
NO-DECOMPRESSION STOP TIME LIMIT IS 38 MIN.
ELAPSED DIVE TIME IS 13 MIN.
Alternative displays, by pressing the UP/DOWN buttons, show:
•
the elapsed dive time in minutes, shown as DIVE TIME
• the water temperature in °C/°F
• the maximum depth during this dive in meters/feet, indicated as MAX
• the current time, shown as TIME
DOWN BUTTON TOGGLES
BETWEEN MAXIMUM DEPTH,
CURRENT TIME AND TANK
PRESSURE.
29