MITSUBISHI ELECTRIC MDT701S - Manual (Page 29)

English-25
English
P-5 Installing the expansion module (continued)
Carry out as necessary
Connecting OPS-compliant computer
Operation of all types of OPS-compliant computers isn’t
guaranteed.
Recommended computer (commercially available):
ARK-DS220F-MTSA1E of Advantech Co., Ltd.
NOTE:
When an OPS-compliant computer (commercially available)
is mounted, set “COOLING FAN” to ON using the SCREEN
SAVER function. See page 52.
1. Mounting the OPS-compliant computer
on the monitor
1. Turn off the main power switch of the monitor and
disconnect the power cord.
CAUTION:
Be sure to disconnect the power cord to prevent breakdown
and electric shock.
2. Unscrew 2 screws and remove the option cover.
NOTE:
Retain the option cover you have removed because it is
replaced when the OPS-compliant computer isn’t mounted.
3. Insert an OPS-compliant computer (commercially available)
in the option slot and secure it on the monitor using the 2
screws that you have removed in step 2.
CAUTION:
Pay careful attention to the position and orientation of the
OPS-compliant computer and insert it as far as it will go.
The device may be damaged if installed in an incorrect
position and orientation.
Removal of the OPS-compliant computer
Hold the handle on the OPS-compliant computer for removal.
CAUTION:
Extract the OPS-compliant computer by using the handle only.
Pulling on the cable or other means may cause damage.
Option cover
OPS-compliant computer
(commercially available)
Option slot