MITSUBISHI ELECTRIC MDT552S - Manual (Page 19)

English-15
English
Preventing the handles from
touching the wall
By attaching the handles in the opposite orientation, you can
reduce the depth of the monitor.
1. Remove the screws that are holding the handles.
2. Attach the handles in the opposite orientation and secure
them using the screws you have removed in step 1.
Removing the stand guide frames
By removing the stand guide frames, you can reduce the depth
of the monitor.
1. Remove the screws that are holding the stand guide frames.
Using the wall mount spacers
When the option slot cover or the stand guide frames touch
the wall or block the heat dissipating holes in the rear of the
monitor, use the wall mount spacers (accessories) to mount the
metal bracket (commercially available).
1. Put the wall mount spacers (9 pcs.) between the metal
bracket and the wall mount screw holes of the monitor and
attach them using screws (a).
(a)
For mounting, use M6 iron screws (with a loose-proof
spring washer, long enough to accommodate the thickness
of the metal bracket and that of the wall mount spacer
(17 mm) and penetrate the monitor to a depth of 10 mm) and
tighten them securely.
10 mm
17 mm
339
276
Normal handle position
Handle
Screws
Screw x 4
Handle position for shallow depth
Handle
Screws
Screw x 4
Stand guide frame
Screws
Screw x 4
Wall mount spacer
(accessory)
(a): Screw for attaching the wall mount spacer (M6, 9 pcs.)
Screw
Metal bracket
Wall mount spacer
(accessory)
Monitor
2. Slightly move and remove the stand guide frames.
NOTE:
• Retain the stand guide frames and the screws that you have
removed because they are necessary to install the monitor
using the option stands.
Stand guide frames
Option slot cover
(accessory)
P-2 Installing the monitor (continued)
Carry out as necessary