MITSUBISHI ELECTRIC MDT552S - Manual (Page 30)

English-26
P-5 Installing the expansion module (continued)
Carry out as necessary
Connecting OPS-compliant computer
Operation of all types of OPS-compliant computers isn’t
guaranteed.
Recommended computer (commercially available):
ARK-DS220F-MTSA1E of Advantech Co., Ltd.
NOTE:
When an OPS-compliant computer (commercially available)
is mounted, set “COOLING FAN” to ON using the SCREEN
SAVER function. See page 53.
1. Mounting the OPS-compliant computer
on the monitor
1. Turn off the main power switch of the monitor and
disconnect the power cord.
CAUTION:
Be sure to disconnect the power cord to prevent breakdown
and electric shock.
2. Unscrew 2 screws (a) and remove the handle.
Unscrew 7 screws (b) and remove the option cover.
(b)
(b)
(b)
(b)
(a)
(a)
NOTE:
Retain the option cover you have removed because it is
replaced when the OPS-compliant computer isn’t mounted.
3. Install the option slot cover (accessory) using the 5 screws (b)
that you have removed in step 2.
(b)
Removal of the SDI BOX
Hold the handle on the SDI BOX for removal.
CAUTION:
Use the handle to extract the SDI BOX only. Pulling on the SDI
cable (BNC) or by other means may cause damage.
4. Insert an OPS-compliant computer (commercially available)
in the option slot and secure it on the monitor using the
2 screws (b) that you have removed in step 2.
Attach the handle using the 2 screws (a) that you have
removed in step 2.
(a)
(b)
CAUTION:
After installing the option slot cover, ensure that the OPS-
compliant computer is positioned and oriented properly and
then insert it fully into the slot. The device may be damaged
if installed in an incorrect position and orientation.
Removal of the OPS-compliant computer
Hold the handle on the OPS-compliant computer for removal.
CAUTION:
Extract the OPS-compliant computer by using the handle only.
Pulling on the cable or other means may cause damage.
Option cover
Handle
Option slot cover
(accessory)
OPS-compliant computer
(commercially available)
Handle
Option slot