Using the standby receptions, English, Ta standby reception – JVC KD-SC402 User Manual

Page 8: Pty standby reception

Advertising
background image

8

ENGLISH

To activate and select your favorite PTY code for
PTY Standby Reception,
see page 14.
The PTY indicator either lights up or flashes.
• If the PTY indicator lights up, PTY Standby Reception

is activated.

• If the PTY indicator flashes, PTY Standby Reception is

not yet activated.

To activate PTY Standby Reception, tune in to another

station providing these signals. The PTY indicator will
stop flashing and remain lit.

To deactivate the PTY Standby Reception, select
“OFF” for the PTY code (see page 14). The PTY indicator
goes off.

Tracing the same programme—

Network-Tracking Reception

When driving in an area where FM reception is not
sufficient enough, this unit automatically tunes in to
another FM RDS station of the same network, possibly
broadcasting the same programme with stronger
signals (see the illustration below).

When shipped from the factory, Network-Tracking
Reception is activated.
To change the Network-Tracking Reception
setting,
see “AF-REG” on page 13.

Programme A broadcasting on different frequency areas
(01 – 05)

3

Repeat steps

1 and 2 to store other PTY

codes into other preset numbers.

4

Finish the procedure.

Using the standby receptions

TA Standby Reception

TA Standby Reception allows the unit to switch
temporarily to Traffic Announcement (TA) from any
source other than AM.
The volume changes to the preset TA volume level if the
current level is lower than the preset level (see page 14).

To activate TA Standby Reception

The TP (Traffic Programme) indicator
either lights up or flashes.

• If the TP indicator lights up, TA Standby Reception is

activated.

• If the TP indicator flashes, TA Standby Reception is

not yet activated. (This occurs when you are listening
to an FM station without the RDS signals required for
TA Standby Reception.)

To activate TA Standby Reception, tune in to another

station providing these signals. The TP indicator will
stop flashing and remain lit.

To deactivate the TA Standby Reception

The TP indicator goes off.

PTY Standby Reception

PTY Standby Reception allows the unit to switch
temporarily to your favorite PTY programme from any
source other than AM.

EN06-13_KD-G431_003A_f.indd 8

EN06-13_KD-G431_003A_f.indd 8

9/21/06 11:21:40 AM

9/21/06 11:21:40 AM

Advertising