JVC KD-R402 - Manual (Page 18)

ENGLISH
18
Category Menu items Selectable settings, [reference page]
AUDIO
FADER * 7, * 8
Fader
R06 – F06 : Adjust the front and rear speaker output balance.
(Initial: 00)
BALANCE * 8
Balance
L06 – R06 : Adjust the left and right speaker output balance.
(Initial: 00)
LOUD
Loudness • LOUD OFF
• LOUD ON : Cancels.
: Boost low and high frequencies to produce a well-balanced
sound at a low volume level.
VOL ADJUST
Volume adjust VOL ADJ –05
—
VOL ADJ +05
(Initial: VOL
ADJ 00) : Preset the volume adjustment level of each source (except
FM), compared to the FM volume level. The volume level
will automatically increase or decrease when you change the
source.
• Before making an adjustment, select the source you want to
adjust.
• “VOL ADJ FIX” appears on the display if “FM” is selected as
the source.
L/O MODE
Line output
mode • SUB.W
• REAR
: Select if the REAR LINE OUT terminals are used for connecting
a subwoofer (through an external amplifier).
: Select if the REAR LINE OUT terminals are used for connecting
the speakers (through an external amplifier).
SUB.W FREQ * 9
Subwoofer
cutoff frequency
• LOW
• MID
• HIGH : Frequencies lower than 72 Hz are sent to the subwoofer.
: Frequencies lower than 111 Hz are sent to the subwoofer.
: Frequencies lower than 157 Hz are sent to the subwoofer.
SUB.W LEVEL * 9
Subwoofer level
SUB.W 00
— SUB.W 08 : Adjust the subwoofer output level.
(Initial: SUB.W 04)
BEEP
Key touch tone • BEEP OFF
• BEEP ON : Deactivates the key touch tone.
: Activates the key touch tone.
TEL MUTING
Telephone
muting • MUTING 1/
MUTING 2
• MUTING OFF
: Select either one which mutes the sounds while using a
cellular phone.
: Cancels.
AMP GAIN * 10
Amplifier gain
control
• LOW POWER
• HIGH POWER
: VOLUME 00 – VOLUME 30 (Select if the maximum power
of each speaker is less than 50 W to prevent damaging the
speaker.)
: VOLUME 00 – VOLUME 50
* 7 If you are using a two-speaker system, set the fader level to “00.”
* 8 This adjustment will not affect the subwoofer output.
* 9 Displayed only when “ L/O MODE” is set to “SUB.W.”
* 10 The volume level automatically changes to “VOLUME 30” if you change to “ LOW POWER” with the volume level
set higher than “VOLUME 30.”
EN16-21_KD-R501_003A_f.indd 18 EN16-21_KD-R501_003A_f.indd 18 9/10/08 11:11:33 AM 9/10/08 11:11:33 AM