JVC KW-AVX810 - Manual (Page 65)

SETTINGS
65
ENGLISH
Equalizer
Flat/Hard Rock/R&B/Pop/Jazz/Dance/Country/Reggae/Classic/User1/User2/User3 ☞ [57]
Sound
Menu items Selectable settings, [reference page]
Fader/Balance Adjust fader—speaker output balance between the front and rear speakers.
• Upmost—front only (F6)
• Downmost—rear only (R6)
When using a two-speaker system, set the fader to the center (0).
Adjust balance—speaker output balance between the left and right speakers.
• Leftmost—left only (L6)
• Rightmost—right only (R6) Initial 0
Volume Adjust * 5 Adjust and store auto-adjustment volume level for each source, comparing to
the FM volume level. The volume level will automatically increase or decrease
when you change the source.
–12 to +12; Initial 00
Subwoofer Level Adjust the subwoofer output level. Level: –06 to +08; Initial 00
High Pass Filter Through: Select when the subwoofer is not connected.
On: Select when the subwoofer is connected.
Crossover Adjust the crossover frequency between the front/rear speakers and the
subwoofer.
80Hz, 120Hz, 150Hz
Amplifier Gain You can change the maximum volume level of this unit.
Off: Deactivates the built-in amplifier.
Low: VOL 00 to 30 (Select this if the maximum power of the speakers is less
than 50 W.)
High: VOL 00 to 50
* 5 For digital sources: you can make the adjustments separately depending on the audio format—Dolby Digital/DTS
and the others.
Fader/Balance
Back Exit
Reset
Fader 0
Balance 0
The procedure for setting an item is shown on page 59.
EN_KW-AVX810[E]f.indb 65 EN_KW-AVX810[E]f.indb 65 08.1.25 7:46:10 PM 08.1.25 7:46:10 PM