Candy FC 4440 X - Manual (Page 38)

Digital clock
Indicates the hours (0-24) and minutes.
Immediately after connection (as well as after a
power outage), THREE intermittent numerals are
shown on the display.
To set the correct time, press simultaneously
TIMER
+ END and AT THE SAME TIME one of
the buttons or until you have the correct
time.
The speed with which the numerals change on the
display increases substantially a few seconds after
pressing the buttons
and .
Manual cooking
(without programmer)
To use the oven without the programmer, you will
need to cancel the flashing «AUTO» message. To
do so, just press the button .
If the «AUTO» message is steady, showing that
the oven has been programmed, you will need to
cancel the programme by pressing so that the
display shows zero.
Automatic cooking
(cooking start and stop)
1) Programme the length of cooking time with
TIMER
.
2) Programme the cooking stop time with END.
3) Select the desired temperature and function
using the controls of the thermostat and selector.
After doing the above, the display will show the
«AUTO»symbol on steady, indicating that the
oven has been programmed.
As an example: you want to cook for 45 minutes,
ending at 14.00.
- Press TIMER to show 0.45 on the display.
- Press END to show 14.00 on the display.
After doing this, the display will once again show
the current time and the «AUTO» symbol, to
indicate that your programming has been
understood and memorized.
At 13.15 (14.00 less 45 minutes), the oven will
start automatically, and during cooking the
symbols
TIMER and «AUTO» will be shown.
At 14.00 cooking will stop automatically. A signal
will sound, which you can stop by pressing .
36