Candy FC 4440 X - Manual (Page 39)

Semi-automatic cooking
A. Programming of cooking time.
B. Programming of end of cooking time.
A) Set the desired cooking time using the button
TIMER
.
Cooking will start immediately, and the display
will show the symbols «AUTO» and
TIMER.
When the programmed time has expired, cooking
will stop, and an intermittent signal will sound.
You can stop the signal as described above.
B) Set the desired end of cooking time using the
button
END. Cooking will start immediately, and
the display will show the symbols «AUTO» and
TIMER
.
At the established time, cooking will stop, and an
intermittent signal will sound.
You can stop the signal as described above.
It is possible to view the programming status at
any time by pressing the corresponding button.
You can also cancel programming at any time by
pressing the button
TIMER and setting the display
to zero. If you then press you will set up the
oven for manual operation.
Electronic signal
The function of the «timer» consists simply of an
acoustic signal which can be set for a maximum
period of up to 23 hours and 59 minutes.
To set the timer, press and at the same time
or until the display shows the desired time.
When setting is complete, the clock will once
again show on the display along with the symbol
.
The countdown will start immediately and you
will be able to view it on the display at any time
by pressing the button .
After the set time has expired, the symbol will
go off and an acoustic signal will sound, which
you can shut off by pressing the button .
ATTENTION! A power outage will cause deletion
of programmed functions, including the clock.
Once you have reset the time, three intermittent
zeroes will appear, and you can re-programme.
37