Accusys ExaRAID A24U-SJ - Manual (Page 26)

JBOD System
Quick Start Guide
24
Configuring the RAID System
Figure 1-3 shows an example of a RAID system (A16R-FS) connected to
three JBODs.
To establish the connection, follow the procedures below:
1.Connect the RAID system and the JBOD enclusures following the
procedures inExpanding JBOD Enclosures on page 19.
2.Connect the RAID system to the host server using fibre cables as shown.
3.Connect controller A and controller B of the RAID system to the LAN
switch.
Note
The same procedures apply to A16R-SS RAID system using SAS
connectors.
TV OUT
A16R-SJ
ID : 2
A16R-SJ
ID : 3
A16R-SJ
ID : 1
A16R-FS/SS
ID : 0
Fibre Card 2
Fibre Card 1
LAN Switch
Host Sever
Figure 1-3 RAID system with JBOD expansion