Accusys ExaRAID A24U-SJ - Manual (Page 28)

JBOD System
Quick Start Guide
26
• To configure using CLI
The Command Line Interface (CLI) is a set of commands which allows
users to configure or monitor the system by entering lines of text through
a variety of terminal consoles. For more information about the CLI
commands, please refer to the software manual.
To perform basic configurations, follow the steps below:
1.Login to the CLI utility.
2.Check the hard disk condition, type hddlist all in the command line
(CLI>).
3.Create disk groups using the dgcreate command.
Note
For more details on GUI configuration, please see Chapter 2 Using
the RAID GUI in the Accusys RAID GUI user’s manual.
Command dgcreate
Synopsis
dgcreate dgi hddx hddy ... [-n name] [-i par/seq] [-z]
[-s hddz,hdda, ...] [-t capacity]
Description Create a disk group with member disks.