ACR&Artex 2-Wire ELT__RSWT Interface - Manual (Page 22)

ACR Electronics, Inc. 570-0049 Revision B
The information within this document and any attached materials is proprietary and confidential
and is not to be disseminated, distributed, or otherwise conveyed throughout your organization to
employees without a need for this information or to any third parties without the express written
permission of ACR Electronics, Inc.
Page 22 of 30
9. PANEL CUTOUT/TOGGLE SWITCH INSTALLATION
9.1 INSTRUCTIONS
NOTE: The toggle switch 140-3349 is not available with a protective guard.
9.1.1 Select a mounting location where the toggle switch can be seen from the pilot’s seated location,
easily be reached by the pilot, out of direct sunlight, and can accommodate the switch and the
label.
9.1.2 Choose the appropriate label based on the orientation on the control panel. Label 591-0037 and
label 591-0092 are provided in the 455-0049 pack list.
591-0037 Label 591-0092 Label
Figure 6 : Label 591-0037 & 591-0092
9.1.3 Create a cutout in the panel for the toggle switch according to the minimum dimensions specified
below.
NOTES: The maximum panel thickness is .102” (2.6mm).
The .087” (2.21mm) diameter hole is intended to prevent the toggle switch from rotating
once the locking ring is installed.
9.1.4 Adjust the hole-pattern appropriately on the panel depending on the orientation of the remote
switch.
NOTE: Ø is the symbol for diameter
591-0037 Label Cutout Orientation 591-0092 Label Cutout Orientation
Tolerance: +.020, -.000
Figure 7 : Panel cutout dimensions
9.1.5 Clean the application surface area thoroughly prior to applying the label.
9.1.6 Remove the paper backing from the label and line up the label over the cutout.
9.1.7 Press firmly and evenly over the label to produce maximum adhesion.