ACR&Artex 2-Wire ELT__RSWT Interface - Manual (Page 23)

ACR Electronics, Inc. 570-0049 Revision B
The information within this document and any attached materials is proprietary and confidential
and is not to be disseminated, distributed, or otherwise conveyed throughout your organization to
employees without a need for this information or to any third parties without the express written
permission of ACR Electronics, Inc.
Page 23 of 30
9.1.8 Slide the locking ring on the toggle switch.
Figure 8: Toggle Switch Locking Ring
9.1.9 Slide the bat of the toggle switch through the cutout and insert the tongue of the locking ring
inside the smaller hole.
9.1.10 Install the lockwasher and the mounting nut over the thread of the toggle switch.
9.1.11 Secure the nut using a torque screwdriver set to 6 lb-in (.67 Nm).
591-0037 Label Assembly 591-0092 Label Assembly
Figure 9: Hardware installation
9.1.12 Fasten the harness to the aircraft and ensure that it has enough slack to prevent tensile load on
the contacts of the toggle switch.
9.1.13 Plug the D-sub connector leading from the harness on the toggle switch to the 453-0032
interface.
9.1.14 Refer to the Transmitter Test section of the appropriate ELT manual to check the operation of the
complete connection to the ELT.
Locking Ring
Tongue
Bat