ACR&Artex 2-Wire ELT__RSWT Interface - Manual (Page 9)

ACR Electronics, Inc. 570-0049 Revision B
The information within this document and any attached materials is proprietary and confidential
and is not to be disseminated, distributed, or otherwise conveyed throughout your organization to
employees without a need for this information or to any third parties without the express written
permission of ACR Electronics, Inc.
Page 9 of 30
3. INSTALLATION AND WIRING OVERVIEW
3.1 INSTALLATION OVERVIEW
The installation below is shown without an ELT.
Figure 1: Installation Overview
NOTE TO INSTALLERS:
READ SECTION 3.2 SYSTEM OVERVIEW FOR RECOMMENDED
INSTALLATION SEQUENCE.
Two-communication wires
across the aircraft
(Refer to section 6 for wiring)
Aircraft power wires 14 or 28 VDC
(Refer to section 7 for wiring)
To ELT
(Refer to applicable
ELT manual for wiring) 453-0041
(Refer to section 5 and 6 for wiring)
453-0032
(Refer to section 6
and 7 for wiring)
Toggle switch 140-3349
(Refer to section 7 for wiring)