ACR&Artex 2-Wire ELT__RSWT Interface - Manual (Page 8)

ACR Electronics, Inc. 570-0049 Revision B
The information within this document and any attached materials is proprietary and confidential
and is not to be disseminated, distributed, or otherwise conveyed throughout your organization to
employees without a need for this information or to any third parties without the express written
permission of ACR Electronics, Inc.
Page 8 of 30
QUANTITY PART NUMBER DESCRIPTION
455-0049 Pack List, 2-Wire ELT/RSWT Interface
2 ea. 120-4007 Diode, 1N4007
1 ea. 140-3349 Switch, DPDT W/LED Tip 2-Pos.
1 ea. 455-0032 Pack List, 2-Wire RSWT Interface 453-0032
1 ea. 455-0041 Pack List, 2-Wire ELT Interface 453-0041
1 ea. 570-0049
Manual, 2-Wire RSWT Interface 455-0032 & ELT
Interface 455-0041
1 ea. 591-0037 Label, Toggle Switch Horizontal
1 ea. 591-0092 Label, Toggle Switch
NOTES: For a new installation, the hardware required to connect the wires to the ELT end is
included in the pack list during the purchase of the beacon.
For an existing installation using an Artex ELT, you can purchase the Installation Kit
based on the ELT series of the beacon that you have if you do not have the necessary hardware
on hand already.
Table 1: Installation Kits
ELT SERIES INSTALLATION KIT PART NUMBER
110-4, 100HM, 110-6 455-7004
C406-1, C406-1HM
C406-2, C406-2HM
G406-1, G406-2
G406-4, G406-4HM
B406-4,
455-7421
C406-N, C406-N HM 455-7422
ME406, ME406HM, ME406P 455-7423