Acroprint Data Collection Terminal (ADCT) - Manual (Page 14)

14
RS-232 Serial port
The RS-232 serial port is located
on the lower left corner of the
terminal. It is a 6 position 4-pin
female port which will accept a
male RJ-11 modular connector.
The Acroprint Data Collection
Terminal can use RS-232 serial
communication to connect directly
to a host computer. A connection
for an IBM PC or compatible is
shown below.
W W AND AND
RS RS
485 485
RS RS
232 232
9V 9V
NOTE: Schematic connections are
shown from END VIEW. (As viewed
from the outside of the connectors.)
Cabling to Host Computer with DB-25 Port
(Use DB-25 RS-232 Host Cable Assembly. See page 26.)
Schematic
"Standard" Modular Cable
Schematic
DB-25 to RJ-11 Adaptor
(Adaptor A)
NOTE: Schematic connections are
shown from END VIEW. (As viewed
from the outside of the connectors.)
Cabling to Host Computer with DB-9 Port
(Use DB-9 RS-232 Host Cable Assembly. See page 27.)
Schematic
"Standard" Modular Cable
DB-9 to RJ-11 Adaptor
(Adaptor A)
Schematic
Ports and connections