Acroprint Data Collection Terminal (ADCT) User Manual
Page 2
2
FCC Warning:
Note: This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. The equipment
generates, uses, and can radiate radio frequency energy. If not installed and
used in accordance with the instruction manual, it may cause interference with
the radio and television reception in a residential area, in which case the user
will be required to correct the interference at his or her own expense.
If this equipment causes interference, try to correct the problem by:
Reorienting the receiving antenna.
Relocating the terminal with respect to the receiver with which it inter-
feres.
Plugging the terminal into a different AC outlet, and putting the terminal
and receiver on different branch circuits.
FCC Compliance: (on hardware equipped with modem)
This equipment complies with Part 68 of FCC Rules. Upon request, furnish the
following information to the telephone company (telco).
Manufacturer: Acroprint Time Recorder Co., Inc.
Model: Badger II Terminal
FCC registration number: 4G3USA-21602-DT-E
Ringer equivalence: 0.7B
USOC modular telephone jack: R-J11
Lithium Battery Caution:
This circuit board on this terminal is populated with a lithium battery to protect
data or programs stored in the Random Access Memory (RAM). Do not, under
any circumstances, attempt to replace the lithium battery in the terminal.
Failure to comply may invalidate your warranty. Battery replacement should be
done by qualified personnel wearing the proper eye protection.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace
only with the same or equivalent type recommended by the manufacturer.
Discard used batteries according to the manufacturers instruction.
Declaration Of Conformity According To EMC Directive 89/336/EEC
We declare under our sole responsibility that the magnetic stripe and/or bar
code reading and/or data recording equipment Badger II 01-0119-000/003/
005/007 to which this declaration relates are in conformity with the following
standards: EN55022:1987, EN50082-1, IEC 801-2, IEC 801-3, IEC 801-4,
IEC 801-5. I, the undersigned, hereby declare that the equipment specified
above conforms to the above directive and standards.
Raleigh, North Carolina
USA
October 7, 2002
W. Glenn Robbins
All Rights Reserved. © COPYRIGHT 1996
Acroprint Time Recorder Company