Maintenance – Activeforever Phoenix Model 1850 Knee CPM User Manual
Page 11
MAINTENANCE
Recommended Tools
After each use, clean the unit using a soft cloth dampened with water and a mild antibacterial detergent or sani-cloth
disinfecting wipe.
Pendant Care
The pendant is a vital component of the entire CPM device. Furniss Corp builds two types of pendants for the equipment
manufactured. The Phoenix Model 1850 and the DC2480 feature a digital pendant and the Phoenix Model 1800 maintains an
analog hand control.
Digital Pendant (Model 1850/ Model DC2480):
Inspect the overlay for any damage. Confirm operation of the pendant cable. Replace as needed.
Analog Pendant (Model 1800):
Fasten the Start/Stop switch tightly. Secure the control knobs. Verify operation of the pendant cable. Replace as needed.
Tighten All Fasteners
Ensure all of the knobs, screws, bolts and other fasteners are secure to maintain operational use. It is recommend that these
parts are checked each time a unit is placed on a patient to guarantee peak performance. A suggested Locktite product assists
to secure the fasteners. Contact the Technical Service Department for recommendations on which type of Locktite to use on
certain fasteners. Toll free 800.273.5233.
Small Phillips Screwdriver
1/8 T Handle Allen Wrench
Basic Volt Meter
Small Flat Head Screwdriver 3/32 T Handle Allen Wrench
Light Building Grease
(front end cap roller bearing)
Phillips Screwdriver
9/64 T Handle Allen Wrench
Red Loctite
(shoulder bolt/acorn nut/calf + thigh tube bolt)
Large Flat Head Screwdriver 5/32 T Handle Allen Wrench
Blue Loctite
(strut support bolt/set screws on pulleys + couplings)
Small Needle Nose Pliers
3/4 Wrench
(pendant cable/knee pot strain relief)
Purple Loctite
(thigh block screws/small allen bolt in foot plate)
Standard Pliers
5/64 Hex Key Allen Wrench
(set screws)
Cleaning Supplies for adhesive removal / Goo Gone
Vise Grips
7/16 Nut Driver
(foot plate)
100% Clear Silicone Adhesive
(Order # adhesive)
Small Rubber Hammer
Small Crescent Wrench
Velcro Cleaner