Activeforever Invacare Tracer IV Wheelchair - Manual (Page 27)

SECTION 4—FRONT RIGGINGS
Part No. 1110558 27 Tracer ® IV
Adjusting Footplate Height
Spring Button Height
NOTE: For this procedure, refer to FIGURE 4.2.
NOTE: This procedure applies to the swingaway front riggings and swingaway elevating legrest.
1. Remove the front rigging assembly. Refer to Installing/Removing Front Riggings on
page 26.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever up to unlocked
position.
NOTE: The elevating legrest has two sets of
release buttons, one set above the other. Each set
will be visible one at a time allowing finer
footplate height adjustment.
3. Push in the release buttons and
reposition the footplate assembly to the
desired height.
4. Ensure that the release buttons fully
protrude from holes on both sides of
the front rigging support.
5. Rotate cam lock lever down to locked
position.
6. Repeat this procedure for the other
footplate, if necessary.
FIGURE 4.2 Spring Button Height
7. Reinstall the swingaway front rigging assembly. Refer to Installing/Removing Front
Riggings on page 26.
Bolt-In-Place Height
NOTE: For this procedure, refer to FIGURE 4.3 on page 28.
NOTE: This procedure applies to the swingaway footrests and swingaway elevating legrest.
1. Remove the swingaway front rigging. Refer to Installing/Removing Front Riggings on
page 26.
NOTE: Lay the front rigging assembly on a flat surface to simplify this procedure.
2. Pull the cam lock lever up to the unlocked position.
3. Using a screw driver to hold the threaded rivet in position, remove the button head
screw from the threaded rivet.
4. Remove the threaded rivet and button head screw securing the footplate assembly to
the front rigging support.
Front Rigging Support
Release Button
Footplate
Assembly
Cam Lock Lever
Adjustment
Holes
NOTE: Swingaway footrest shown.