Activeforever Respironics EverGo Portable Oxygen Concentrator - Manual (Page 13)

10
EverGo User Manual
Charging the Battery(s) with AC Power Supply
Important: The first time you charge the battery(s), be sure to charge it fully. Do
not use the DC power cord to do so; instead use AC power.
Note: The battery(s) will begin charging whenever you connect the device to an
AC outlet, even if you’re using it.
To charge the battery(s) using the AC Power Cord provided with your system,
follow these steps.
1. Connect the output cable of the AC Power Supply to the EverGo
power inlet.
2. Connect the connector of the AC Power Cord into the AC power
supply.
3. Connect the plug of the AC Power Cord into an AC outlet installed
to meet national or regional electrical code.
Figure 6. Connecting the power cord to the connector located under the Velcro flap.
A typical battery charging screen is shown on the right
Note: As soon as you connect the device to an energized AC power
source, the light on the AC Power Supply will light up and the cooling
fan will come on. This is normal. The fan will run the entire time it is
charging to keep the battery(s) cool.
4. When charging is complete (this takes a minimum of four hours
for first use), disconnect the AC Power Supply and store it with the
AC Power Cord for future
VTF
VER 1.0.0.0
www.ActiveForever.com