Acura 2013 TL Navigation - Manual (Page 115)

System Setup
Navigation System 115
Time Adjustment
Adjusts the current time in hours and
minutes. Select the current time by
moving the
Interface Dial up, and
then switch HOUR and MINUTE
by moving the Interface Dial to
the left and right and changing the
value by rotating the
Interface Dial
knob . Selecting OK returns you to
the previous screen. You can reset the
adjustment by selecting
RESET .
NOTE:
Selecting
RESET also clears any
changes you made to “Auto Daylight,”
or “Auto Time Zone” settings.
Depending on your location, you may
need to adjust these settings.
Vehicle
From the SET UP screen (Other), say
or select Vehicle and the following
screen appears:
Off-road Tracking
With this ON , the system will
provide white off-road tracking dots
(“breadcrumbs”) on the
map screen
whenever you drive into an area where
the map does not show any roads. See
Map Screen Legend on page
20 .
After you have traveled approximately
1/2 mile away from a mapped road, the
system will display a series of white
dots on the
map screen to show the
path you have traveled. This is provided
so you can follow the dots to backtrack
to the mapped road you originally left.
Tracking continues until you reach a
mapped road. See Off-road Tracking on
page
72 .
Tracking is shown only in the 1/20, 1/8,
1/4, and 1/2 mile scales, or the 80, 200,
400, and 800 meter scales. Rotate the
Interface Dial knob to change the
scale if necessary.
NOTE:
To clear existing dots, turn this feature
OFF and exit SET UP. To re-enable
this feature, return to SET UP and turn
it on again.
2013 TL