Acura 2013 TL Navigation - Manual (Page 44)

Entering a Destination
44 Navigation System
By Coordinate
If you select Coordinate from the
DEST screen ( Dest. MENU 2 ),
the display will change to the Enter
Latitude screen. Use the Interface
Dial to input the latitude.
NOTE:
Latitude and longitude must be entered
up to the seconds’ value.
NOTE:
Prior to departure, you can set areas to
avoid. The system then includes them in
its calculations for the destination you
have entered. See Edit Avoid Area on
page
110 .
After entering the latitude, move the
Interface Dial down and select OK .
The display will change as indicated in
the following paragraph.
On the Enter Longitude screen,
use the Interface Dial to input
the longitude.
With the selection of Coordinate , it
is assumed that you are searching for
the destination within the area that is in
the closest proximity. The display will
change as indicated on the next page.
Move the Interface Dial to fi nd the
desired destination. The map and
crosshairs move in the same direction.
If so desired, you can also rotate the
Interface Dial knob and change the
scale of the map. When the crosshairs
are on the desired icon, map location,
or road, push in on the
Interface Dial .
The address for this location will be
displayed at the very top of the screen.
The yellow box (shown in scales above
1 mile) denotes the area that can be
viewed with the
Interface Dial when
the current map is clicked.
2013 TL