Acura 2013 TL Navigation - Manual (Page 46)

Entering a Destination
46 Navigation System
By Map Input
After you select Map Input from the
DEST screen ( Dest. MENU 2 ), the
display changes to:
Select Current Position , City , State ,
or USA , Canada , and Mexico to
display the map.
NOTE:
• Prior to departure, you can set areas
to avoid. The system then includes
them in its calculations for the
destination you have entered. See
Edit Avoid Area on page
110 .
• For information on the available
voice commands, see Voice
Command Index on page
167 .
Showing the Map of Current
Position
The Current Position selection
assumes that you are looking for a
destination in the immediate area. The
display changes to:
The red arrow indicates your vehicle
position. Find your desired destination
by moving the
Interface Dial up and
down and to the left and right. The
map and crosshairs will move in the
same direction.
The yellow box indicates the area you
will see when you click on the current
map with the
Interface Dial . The
scale will decrease each time you push
in the
Interface Dial .
If desired, rotate the Interface Dial
knob to change the map scale. When
you have the crosshairs on the desired
icon, polygon, or road, push in on the
Interface Dial . The address of the
location will appear at the top of the
screen (at scales less than 1 mile).
NOTE:
Information icons are displayed at
scales from 1 mile to 1/4 mile, POI
icons are displayed at 1/8 mile or
less, and roads are displayed at 1/4
mile or less.
If this is the desired address, push in
on the
Interface Dial again. If not,
use the Interface Dial to reposition
the crosshairs, then push in on the
Interface Dial again to display the
new address.
If you select a single icon or road
segment within the target mark, the
following screen appears. Select
Set
as Dest . to calculate a route to the
selected destination.
2013 TL