Olympus IX71 - Manual (Page 61)

57
IX71/IX51
System Using the IX2-ILL30 Illumination Column
}The IX2-ILL30 illumination column can be attached in the same manner
as the IX2-ILL100.
2 Attaching the Halogen Bulb (Figs. 80 to 82)
}The applicable lamp bulb model is the 6V30WHAL (PHILIPS 5761) high-
intensity halogen bulb.
Do not touch the halogen bulb directly. If it is stained with
fingerprints, etc., wipe off completely with a soft cloth in order to
prevent shortening of the bulb life or cracking of the bulb.
1. Hold the halogen bulb @ with gloves or a piece of gauze, insert the bulb
pins ² straight and fully into the pin holes ³ on the lamp socket.
# Push in gently. If an excessive force is applied or the bulb is twisted,
the bulb may be damaged.
Caution for Bulb Replacement During or Right After Use
The bulb, lamp socket and areas near these will be extremely hot
during and right after use.
Set the main switch to “ ” (OFF), disconnect the power cord from
the wall outlet, then allow the old bulb and lamp socket to cool be-
fore replacing the bulb with a new of the designated type.
Attaching the Condenser (Fig. 81)
1. Align the index groove ² on the condenser @ with the dent section ³ of
the illumination column and fit the condenser @.
2. Rotate the condenser @ by 90° clockwise so that characters “AS” | on
the filter holder surface faces the front, then attach and tighten firmly the
provided clamping screw ƒ using the Allen wrench provided with the
microscope frame.
1 (Fig. 76 on the previous page)
Mounting the Illumination
Column
Fig. 80
@
²
³
Fig. 81
@
²
³
|
Fig. 82
@
²
³
|
Attaching the Lamp Socket (Fig. 82)
· Insert the plug @ into the socket ², then push the guide pins ³ gently
into the guide holes | on the condenser.
ƒ