Garmin GPS III - Manual (Page 89)

RAM Failed—The GPS III has detected a failure in its
internal memory. If the message persists, the GPS III is
unusable and should be taken to an authorized GARMIN
service center.
Received Invalid Waypoint—A waypoint was received
during upload transfer that has an invalid identifier.
Receiver Failed—A failure in receiver hardware has
been detected. If this message persists, do not use the
unit and take it to an authorized dealer for repair.
ROM Failed—The permanent memory has failed and
the unit is not operable. Take your unit to an authorized
GARMIN dealer for repairs.
Route Already Exists—You have attempted to name a
route with the same name currently in use with an exist-
ing route. Enter a different name for the route.
Route Full—You have attempted to add more than 30
waypoints to a route.
Route Memory Full—Route memory is full and no
additional routes can be added from another GPS III or
uploaded from a PC.
Route Waypoint Deleted—The waypoint being deleted
was part of a route. The deleted waypoint is removed
from waypoint memory and from the route.
RTCM Input Failed—DGPS data being received has
been lost. You are no longer receiving the beacon signal. Searching the Sky—
The GPS III is in
searching the sky for
almanac data or the unit is in AutoLocate mode.
Steep Turn Ahead—This message appears approxi-
mately one minute prior to a turn that requires a bank
angle in excess of 25 degrees in order to stay on course.
Stored Data Lost—All waypoints, routes, time, and
almanac data have been lost due to battery failure, or the
receiver’s memory has been cleared.
Timer Expired—The countdown timer has expired.
Track Log Already Exist—The name selected for the
track log is identical to another track log already stored
in memory.
Track Memory Full—You have used all track log points
in the GPS III. (The unit holds approximately 1900
points in the active track log.) Delete unwanted track
points to make room for new entries.
Waypoint Memory Full—You have used all 500 way-
points in the GPS III. Delete unwanted waypoints to
make room for new entries.
Waypoint Already Exists—The name you are entering
already exists in the GPS III’s memory.
81
APPENDIX E
Messages
GPS III A 7/21/98 8:52 AM Page 81