Garmin GPSMAP 495 User Manual

Page 124

Advertising
background image

116

GPSMAP 495 Owner’s Manual

Main Menu >

Setup Tab

GARMIN DGPS—used to connect the GPSMAP 495 with a

Garmin DGPS beacon receiver.
Garmin Remote Sonar—supports the input/output of a Garmin

remote sonar device.
NMEA In/NMEA Out—supports the input/output of standard

NMEA 0183 version 3.01 data and sonar NMEA input support

for the DPT, MTW, and VHW sentences.
Aviation In—the proprietary format used for connection to a

Garmin panel-mounted GPS receiver. Allows the GPSMAP 495

to show a Go To or route selected on the panel-mounted GPS

receiver. This eliminates the need to enter the destination on both

units.
Aviation In/NMEA & VHF Out—receives aviation data

and transmits out both NMEA data, at 9600 baud, and VHF

frequency tuning information to a Garmin Nav/Comm radio. See

page 132

.

TIS In—receives TIS data from a Garmin Mode S transponder.

See

page 132

.

TIS In/NMEA & VHF Out—receives TIS data and transmits

out both NMEA data, at 9600 baud, and VHF frequency tuning

information to a Garmin Nav/Comm radio. See

page 132

.

RTCM In—allows Differential GPS (DGPS) input using a

standard RTCM format.

RTCM In/NMEA Out—allows Differential GPS (DGPS) input

using a standard RTCM format and also provides NMEA 0183

version 3.01 output.
RTCM In/Text Out—allows Differential GPS (DGPS) input

using a standard RTCM format and also outputs simple text data

that includes, data, time, location, and velocity.
Text Out—allows the unit to output simple text data that

includes, data, time, location, and velocity. The Baud can be set

to 1200, 2400, 4800, or 9600.
None—provides no interfacing capabilities.

If you select GARMIN DGPS or RTCM In/NMEA Out format,

you can control a differential beacon receiver directly from your

GPSMAP 495 using the Interface sub tab. You can have the unit

automatically scan for the DGPS beacon signal, or you can enter

the beacon frequency and bit rate on the unit, and the information is

used to tune the beacon receiver. If you use a DGPS receiver, WAAS

capability is automatically turned off.

Advertising