Garmin GPSMAP 495 - Manual (Page 166)

158 GPSMAP 495 Owner’s Manual
Appendix > Messages
Track Already Exists—a saved track with the same name already
exists.
Track Log Full—the track log is full and track recording was turned
off. To record more track points, you need to clear the track log and
turn track recording on.
Track Memory Full—no more track data can be stored. Delete the
old track data to store the new data.
Track Truncated—a complete uploaded track will not fit in
memory. The oldest track log points have been deleted.
Transducer Disconnected, Sonar Turned Off—the unit has
no transducer attached, has a bad cable/transducer, or has a
disconnected transducer cable.
Transfer Complete—data transfer was completed.
USB Connected—the USB cable was recently plugged in.
User Timer Expired—the Timer Alarm value has counted down to
zero.
VNAV Cancelled—VNAV function has been cancelled due to a
change in the active route.
Water Speed Sensor is Not Working—the speed sensor is not
detected. Check the connections.
Water Temperature Alarm—sonar has reported a temperature
above, below, inside, or outside the specified values(s).
Waypoint Already Exists—a waypoint with the same name already
exists.
Waypoint Memory Full—the unit has stored the maximum number
of waypoints.
Data Field Options
The following list provides a brief description of each data field
option. Some of these options are supported only by devices
interfaced to your GPSMAP 495.
Accuracy—the current accuracy of your GPS determined location.
Battery Timer—the time remaining on the battery before it is fully
discharged.
Bearing—the compass direction from your current location to a
destination.
Course—the your path of travel from your starting location to a
destination.
Course to Steer—the recommended direction to steer in order to
reduce cross-track error and return to the course line. Shown as
Steer.