Garmin GPSMAP 3010C - Manual (Page 54)

6 GPSMAP 3006C/3010C Owner’s Manual
M
aIn
M
enu
> t
Ide
t
ab
M
aIn
M
enu
Tide Tab
Use the Tide tab to view tide and current information. The Tide tab contains two
sub tabs: Tide and Current.
Tide Sub Tab
The Tide sub tab contains a graphical chart that shows Tide Station information
in a 24-hour span starting at midnight. You can choose from different dates and
more than 3,000 Tide Stations around the USA coastline, Alaska, Hawaii, western
Canada, and several of the Caribbean islands. The top of the Tide sub tab shows
the Tide Station and the date. The bottom of the Tide sub tab shows the distance
and bearing from your location.
The bottom of the Tide chart shows a 24-hour block of local time for your
location. Daylight (yellow bar) and nighttime (blue bar) at the Tide Station are
shown across the time scale, with the time progressing from left to right (sunrise
and sunset information might not be available for some Tide Stations). The solid,
light vertical lines are in 4-hour increments, and the light, dotted vertical lines are
in 1-hour increments. A solid, vertical line (with the local time at the top) indicates
the tide height corresponding to the time shown in the local time box.
Nght Low tde curve Event tmes Mn. level
Max. level Local tme
Day
Hgh tde
curve
Tme bar
Current tde
heght bar
Current
tde
heght
The Tide curve is shown as a shaded area, where higher tides are taller (blue) and
lower tides are shorter (red). The solid, horizontal line indicates the tide height.
The figure to the left of the line shows the present tide level. The Mean Lower
Low Water (MLLW) appears as a solid, horizontal line near the bottom of the chart
(this line appears only if the tide height range is zero or below). The numbers on
the top and bottom of the left side indicate the maximum and minimum levels.
The four data fields below the chart indicate event times and levels at which the
tide changes, starting in the upper-left field, going downward, then to the upper-
right, and down again. When comparing with other tide tables, verify that the
depth unit’s value is the same for both sources. The bottom of the chart shows the
amount of time (in hours and minutes) until the next low tide and high tide.