Garmin GPSMAP 3010C - Manual (Page 69)

GPSMAP 3006C/3010C Owner’s Manual 61
M
aIn
M
enu
> s
YsteM
t
ab
M
aI
n
M
enu
System Tab
The System tab consists of five sub tabs: General, Units, Time, Comm, and
Update.
General Sub Tab
Use the General sub tab to control system settings for System Mode, Speed
Filter, Automatic Backlight, Beeper, Language, Simulator Controls, Restore
Factory Default Settings, and to view the software version.
The following settings and options are available:
• System Mode—select Normal (normal navigation) or Simulator (for
practice only). For more information about Simulator Mode, see “Simulator
Mode” on page 8 .
• Speed Filter—averages speed readings. Select Off, Auto (automatically
controls filtering), or On (allows you to enter a value from
1 to 255 seconds).
• Automatic Backlight—automatically adjusts the display brightness to a
specified level at sunrise and sunset. You can specify offset minutes for
before sunrise and after sunset.
• Beeper—controls the audible beep. Select Off, Alarms Only (sounds for
alarms/messages), or Key and Alarm (sounds for key presses and
alarms/messages).
• language—sets the language for the unit’s on-screen text.
• Services—after a new device is detected on the network, clearing the
Auto-Detect Services check box speeds up the startup sequence. If the
Auto-Detect Services check box is not selected and new hardware is
added, you must select the corresponding service check box to enable the
new hardware device.
The following soft keys are available:
• System Info—shows the unit’s software, basemap version, and electronic
serial number.
• Update Notes—shows software notes for the current software version.
• Factory Dflts—restores all settings to Garmin’s original setup values for
all devices on the network.
To adjust the automatic backlight settings:
1. Highlight the Automatic Backlight field, and press ENTER.
2. Using the ROCKER, highlight On, and press ENTER.
3. Highlight the Setup button, and press ENTER to open the Adjust Backlight
window.
4. To adjust the backlight levels For Day and For Night, highlight the
corresponding slider, and press ENTER.