Spicer TPCS (Tire Pressure Control System) Service Manual - Manual (Page 14)

14
Splicing Wire
Figure 5 shows the steps to splice two sections of wire.
Remove insulation cleanly taking care not to damage
wire strands. Slide automotive grade heat shrink over
area to be sealed and slide to one side. After hand
Figure 5 Splicing Wire
Solder All Hand Splices
Take Care Not To
Cut Wire Strands
Removing Insulation
Cover Entire Splice
with Automotive Grade
Heat Shrink Tubing
2" of Automotive Grade Heat Shrink
(with adheasive lining)
Tubing Extends onto Insulation
on Both Sides of Splice
Electrical Service
Position Both
Wire Ends
in Splice Clip
Slide Automotive
Grade Heat Shrink
to one side.
Tightly Crimp
Spliced Wires
crimping splice clip, the joint should be soldered.
Cover entire splice with automotive grade heat shrink,
making sure heat shrink extends over insulation on
both sides of splice.