Spicer TPCS (Tire Pressure Control System) Service Manual - Manual (Page 26)

26
2. Refer to Figure 14 and remove the damaged or
broken components.
Note: Note the following important points while
performing this procedure:
• The front and rear wire braid hoses must be
equal lengths (see Figure 14).
• The correct length of tubing must be used to
make up the supply section. Do not trim off
any extra tubing; use cable ties to secure any
slack segments. See Figure 9.
• Using compressed air, clean replacement air
line and check for obstructions.
• Figure 13 shows typical mounting locations.
Figure 13 Branch Tee Axle Mounting
!
Typical Axle
Configuration
Tee Mounting
Bracket
Hose Support
Clamp
Hose Support
Clamp
Pneumatic Service
Drive Axle Pneumatic Replacement
Note: Refer to Figures 13 and 14 for the following
steps.
Note: The following procedure discusses replacing the
pneumatics for a Drive Axle. You may not require all
the steps depending on what parts you are replacing.
1. Turn off the vehicle’s ignition and engine.
Warning: Drain off all air from the wet tank before
removing any fittings!